The 300–6000MHz Omnidirectional Broadband Log Periodic Antenna features a rugged enclosure providing reliable outdoor weather protection against UV rays, rain, frost, and temperature fluctuations. Precise internal impedance tuning suppresses signal reflections across the entire operating band, maintaining stable gain and low signal loss. It is suitable for public wireless coverage, drone signal detection, and commercial wireless infrastructure deployments. Its low-profile enclosure design reduces wind resistance, simplifying rooftop, vehicle, pole, and cabinet top mounting in commercial, municipal, and industrial locations.
|
Parameter Item |
Specification |
|
Working Frequency Band |
300 MHz – 6000 MHz |
|
Radiation Pattern |
360° Horizontal Omnidirectional |
|
Polarization |
Vertical Polarization |
|
Nominal Impedance |
50 Ohms |
|
Typical VSWR |
≤1.8 over the full operational band |
|
Antenna Gain |
2.2 ~ 4.2 dBi (band-flattened tuning) |
|
Outer Enclosure Rating |
IP67 Waterproof & Dustproof |
|
RF Connector |
N-Female (custom SMA/TNC available on request) |
|
Endurance Wind Rating |
Resists 12-grade strong wind |
|
Working Ambient Temperature |
-40°C ~ 85°C |
|
Surface Finish |
Matte anti-scratch black coating, anti-UV treatment |
|
Compliance |
CE, RoHS certification |
|
Mounting Methods |
Pole clamp mounting / rooftop screw fixation / equipment top installation |
1. Pick open mounting locations free from large metal obstructions, dense tree cover or tall building blockages to prevent signal attenuation. Keep proper spacing from large metal structures.
2. Fasten mounting hardware tightly per installation guidelines to offset wind vibration; confirm no loose fitting after installment.
3. Seal the connector joint with waterproof tape when running outdoor coaxial cabling, to stop moisture intrusion that triggers unstable contact.
4. Do not apply strong corrosive cleansers on the outer shell during periodic maintenance; wipe dust off with soft dry cloths to preserve housing anti-UV performance.
5. Reach out to our engineering team if customized interface types, mounting accessories or band-specific performance tuning are required for project requirements.